Push Fitting Transition 20 x 2 to 1/2" Male Thread
Info about the Product:
- Push-in fitting transition 20 x 2 to 1/2" AG – easy handling
- High-performance plastic PA6 – high resistance
- Brass parts made of CW617N – stable connection
- EPDM wedge seal – optimal sealing
- No pressing tool required – quick assembly
| Brand: | Pipetec GmbH |
There are no questions yet
Ask a question to learn more about the productReviews (28)
Push Fitting Transition 20 x 2 to 1/2" Male Thread

NO PRESSING - JUST PLUG!
> Cut > Calibrate > Plug > DONE
Advantages:
- No pressing tool necessary
- Outer sleeve made of durable high-performance plastic PA6 for maximum impact resistance
- Automatic sealing by EPDM wedge seal with large safety buffer
- Brass parts made of CW617N (CuZn40Pb2) in heavy-duty design for high installation safety
- Very good resistance coefficient (Zeta) for lower pressure loss
- Free passage and virtually no flow noise
- All materials are safe for use in drinking water and comply with the UBA positive list
- Two inspection windows to check the insertion depth
Properties:
DVGW DW-8501DL0064
Continuous load capacity: 10 bar / 70° C / 50 years
Maximum operating temperature 95° C
Important:
Please use only our calibrator {product=Z52K1626} in gray for calibration!
Application Areas:
Drinking water installations
Surface / Ceiling Heating
Surface / Ceiling Cooling
Radiator Connection
Oil-free Compressed Air up to 10 bar
Certifications:
DVGW (except ball valve for heating)
IMA
EN ISO 21003
Installation Instructions:
With our push fittings, you can quickly and without installation tools create pipe connections.
Only a pipe cutter and a calibrator are needed. The aluminum composite pipe is cut to the desired length with a pipe cutter.
Calibration is necessary so that the pipe end is absolutely round again after cutting and is deburred.
At the same time, calibration creates a chamfer. This allows the fitting to be inserted into the pipe without damaging the sealing ring.
TRIMMING THE PIPE
The pipe should be cut to the desired length with a suitable tool.
The cross-sectional area of the cut must be at a right angle to the pipe. Slanted cuts should be avoided.
Hand and jigsaws as well as blunt tools are not suitable for trimming.
CALIBRATION AND DEBURRING OF THE PIPE
After trimming, the pipe end must be calibrated and deburred.
To do this, the calibrator is first inserted into the pipe up to the stop. Deburring is then done by turning the calibrator.
Material is removed from the inside of the pipe by turning, creating a cone on the pipe,
which facilitates the insertion of the fitting and thus protects the wedge seal from damage.
ATTENTION: Use only our calibrator {product=Z52K1626} in gray for calibration!
INSTALLATION OF THE FITTING
Insert the fitting with appropriate pressure and in an axial direction up to the stop on the pipe end.
The correct insertion depth can be recognized by the two integrated inspection windows. Both inspection windows must be filled by the white pipe.
The fittings are prepared for immediate installation from the factory, please do not use additional lubricants.
FINAL INSPECTION
Check the pipe for a firm fit, the pipe must not be able to be pulled out.
Be sure to perform a pressure and leak test!
Note:
A flawless function of the pipe connection can only be ensured when using the fittings with our DVGW-certified aluminum multilayer composite pipe.
We emphasize the high importance of correct and professional calibration and deburring using a suitable tool.
This is a non-detachable connection!
Please ensure before attaching the fitting that the pipe has the desired length and no mounting clamps etc. need to be pulled over the pipe.